Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SETUP
SETUP
SET UP DAP-1320 WITH ONE-TOUCH AP CONFIGURATION
NOTE: To connect to a wireless router or AP to extend the Wi-Fi network in your
home, please make sure the router or AP features a WPS Push Button.
NOTE:
The DAP-1320 can also be configured in the Web GUI. After you have plugged the
DAP-1320 into a wall outlet and the power LED is blinking amber, go to Wireless
Utility on your computer, select the DAP-1320 network, and enter the password (this
is on your Wi-Fi Configuration Card). Then open a web browser and type http://
dlinkap.local. Follow the onscreen instructions to complete the setup.
DAP-1320
Plug the DAP-1320 into a wall outlet and wait until the
power LED is blinking amber. Push the WPS button on
the wireless Router or AP, and then push and hold the
WPS button on the DAP-1320 for about 5 seconds until
the green LED starts to flash.
Please allow up to two minutes for the process to finish.
The LED will become solid green when the DAP-1320
has connected successfully to the wireless router or AP.
The DAP-1320 is then ready for you to share a Wi-Fi
network with your PCs and mobile devices by using the
network name (SSID) and password located on your Wi-
Fi Configuration Card.
75
Publicidad
