Initial Assembly; Unpacking And Checking Contents - Craftsman 124.3299 Manual Del Operador

1. TOOLS REQUIRED FOR ASSEMBLY
Item Description
Adjustable Wrench................................1
Square..................................................
2.

UNPACKING AND CHECKING CONTENTS

Model 124.3299 9" Band Saw is shipped complete in one box.
A. Separate all parts from carton and check each item with Carton
Contents list below to make sure all items are accounted for, before
discarding any packing material.
B. Remove the protective oil that is applied to the table. Use any
ordinary household type grease and spot remover.
C. Apply a coat of paste wax to the table to prevent rust. Wipe all
parts thoroughly with a clean dry cloth.
CARTON CONTENTS
Item Description
A Main Machine w/Blade Installed................................1
B Operator's Manual...............................................1
C Table.........................................................1
D Upper Table Trunnion Assembly...............................1
E Bag of Loose Parts....................................................1

3. INITIAL ASSEMBLY

The 124.3299 band saw is supplied partly assembled. Prior to use, the following items have to be assembled: Table Trunnion, Table, and
Blade Tension Knob.
WARNING:
To avoid injury, do not attempt to run or use this machine until all parts are assembled and working properly.
A. Assemble the upper table trunnion to the lower table trunnion with
Carriage Bolt, Glide Piece, Washer and Wing Nut (See FIG. 1).
ASSEMBLY
LIST OF LOOSE PARTS IN BAG
Item
Qty.
1
.
Qty.
C
FIG. 1
B. Locate four bolts and four washers used to mount the table. Lay
the table onto the upper table trunnion and install a bolt washer in
each hole, then tighten with " L" wrench provided (See FIG. 2).
4
Description
Washer M6.......................................4
Hex Bolt M6x12................................4
Flat Washer M6................................1
Hex Nut M6
Hex Bolt M6x20................................1
M2 Hex "L" Wrench..........................1
M2.5 Hex "L" Wrench.......................1
M4 Hex "L" Wrench..........................1
M5 Hex "L" Wrench..........................1
Blade Tension Knob.........................1
Miter Gauge.....................................1
A
D
Table Bolts
(x4)
Qty.
......................................1
.
B
E
FIG. 2