Assembling; Starting The Bona Dcs25 And Collecting Dry Dust; Electrical Outlet With Automatic Start/Stop - Bona DCS25 Manual De Funcionamento

Assembling

• Unpack BONA DCS25 and check that all the ordered parts
are there.
• Unpack BONA DCS25 and check that all the ordered parts
are there.
• Make sure that the collection container is empty, and that
the pre-filter / membrane filter is correctly fitted into the
motor top. Check that the filters of the machine are intact
and undamaged (see the chapter:"Change of Filter")
• Check that a collection bag is mounted in the container.
• Before the plug is connected to the electrical main
supply you must make sure that the plug and the cord
are undamaged. If the cord or the plug is damaged, a
professional must replace the parts. Only an original cord
may be mounted.

Starting the BONA DCS25 and Collecting Dry Dust

When the machine has been correctly assembled and
connected, it can be switched on and off at the red start/stop
switch of the motor top. The machine has been equipped with
an acoustic and a visual alarm indicating when the air flow is
too low for collection.

Electrical Outlet with Automatic Start/Stop

• Connect the machine to 230 V power supply with a reliable
earth connection.
• Remember to place the label onto the H-label, if the
language of the user is not German.
• BONA DCS25 is now ready for use. The collection is
described in details in the following chapter.
This alarm has to be checked before use: Block the intake at
the end of the hose, and the machine will start beeping, and
the LED will flash. Unblock, and the alarm will stop.
BONA DCS25 is equipped with an automatic start/stop and electrical outlet. If you
connect electrical hand tools directly to the power outlet of the motor top, the BONA
DCS25 will automatically be switched on and off when the hand tools are switched on
and off.
The automatic start/stop is programmed with a post-suction cycle. Therefore, the
suction will continue for some seconds after the tool has been switched off.
The electrical tool is connected to the electrical outlet at the back of the motor top.
EN
DCS25 Manual
15