Grohe Europlus E 36 211 Manual Del Usuario página 6

Maintenance
Inspect and clean all parts, replace if necessary.
Shut off cold and hot water supply!
I. Battery
Almost depleted battery is displayed by flashing control light.
1. Push on cleaning clip (L), see Fig. [9].
2. Unscrew screw (M) with 2.5mm allen wrench and pull off
body (N).
3. Pull off protection sleeve (O) and remove battery (P), check
contacts, clean and replace if necessary.
Assemble in reverse order.
II. Solenoid valve
1. Proceed as for maintenance of battery, points 1 to 3.
2. Remove screw (R1) and remove battery holder (R),
see Fig. [10].
3. Detach plug-in connector (S) and remove solenoid valve (T)
by turning clockwise using a 5mm allen key, see Fig. [11].
4. Remove filter (U).
Observe installation position!
Assemble in reverse order.
Problem / Cause / Remedy
Problem Cause
• Water supply interrupted
Water does not flow
• Filter before solenoid valve is clogged
• Solenoid valve defective
• Plug connectors of solenoid valve without
contact
• Battery depleted
• Battery almost depleted
Control light flashes
• Solenoid valve defective
Water flows
continuously
• Detect area for the local conditions too
Water flows
inadvertently largely adjusted
• False signal initiation by object within the
area of the sensor technology
• Filters, aerator are dirty
Quantity of water too
• Service valves not fully opened
small
• Water supply throttled
• See point „Quantity of water too small"
faucet set up not
• Mixing spindle calcified
correct
• Temperature limiter not correct setted
3
English
III. Filter and non-return valve
1. Unscrew connection hose and loosen adapter (B), see
Fig. [12].
2. Unmount filter (C).
Assemble in reverse order.
IV. Unscrew and clean aerator (42 832), see fold-out
page I.
Assemble in reverse order.
V. Mixing spindle
1. Loosen faucet from connections.
2. Unmount faucet from basin.
Disassembling as described in chapter „Setting temperature
limiter", see Figs. [5] to [7].
3. Pull out mixing spindle (H, I), see Fig. [13].
Assemble in reverse order.
Screw (W) must fit to groove (H1, I1) of mixing
spindle (H, I).
Replacement parts, see fold-out page I ( * = special
accessories).
Care
Instructions for care of this faucet will be found in the Limited
Warranty supplement.
Remedy
- Open stop valves, service valves
- Clean, see maintenance solenoid valve
- Replace, see maintenance solenoid valve
- Plug together plug connectors
- Replace, see maintenance electronic battery
- Replace, see maintenance electronic battery
- Replace, see maintenance solenoid valve
- Reduce range with remote control (special
accessory, ref No. 36 206)
- Mount base (special accessory, ref No. 36 210)
- Replace, see maintenance filter (III) and aerator (IV)
- Fully open stop valves, service valves
- Check supply pipes, open service valves
- Clean, see maintenance mixing spindle
- Setting, see description