Operation; Heated Banquet Trolleys - Hupfer Kohler BKW1/14 L-GN Manual De Instrucciones

Chapter 5
Page 20
Position digit
1
2
3
5.2

Operation

5.2.1

Heated banquet trolleys

WARNING
WARNING
ATTENTION
ATTENTION
Step 1: Filling the thermal module
The water tank of the thermal module must be filled with water before each operation.
Switch off the appliance. For this, turn the On/Off switch rotary knob with thermostat to the left.
Banquet trolley heated | neutral
BKW1/14 L-GN | BKW1/20 L-GN | BKW1/36 B-GN | BKW1/14 L-GN+5PK | BKW1/28 B-GN+10PK | BKW1/23 L-GN
Operating element
STB button
On/Off switch rotary knob with thermostat
Control lamp
Risk of hot surfaces
If the thermostat is set to the level 3 and higher, the permitted maximum tem-
perature of 149°F (65°C) for touchable appliance surfaces can be exceeded.
This can cause burns.
The appliance set to the level 4 may only be operated by an instructed staff.
Wear suitable protective clothing.
Danger of escaping steam
Hot steam can escape when opening the door. Risk of burning.
Please stay at a safe distance and wait until the steam has volatilised.
Damage to the connecting lead
If the side holder of the BKW1/36 or BKW1/28 model is used for mounting the
connecting lead, it can be damaged when moving the appliance.
The connecting lead is thus no longer located in the protected area of the
bumpers because of the wide design of the model.
Always wind the connecting lead onto the holders provided on the thermal
module before moving the appliance.
Appliance damages
The mains plug of the appliance must not be plugged in or pulled out under
load. The appliance must be switched off (marking of the On/Off switch rotary
knob with thermostat points upwards). The mains plug must only be pulled out
under load in case of an emergency.
Make absolutely certain that the appliance is switched off before plugging in
or pulling out the mains plug.
Function
Springs out, if the safety temperature limiter has
been triggered.
Controls heating and maintains the selected
temperature.
The levels of the On/Off switch rotary knob with
thermostat correspond to the following tempera-
tures:
0 off
1 approx. 77°F (25°C)
2 approx. 122°F (50°C)
3 approx.167°F (75°C)
4 approx. 203°F (95°C).
Light is on, if the heating runs and functions prop-
erly. If the temperature has been achieved, the
control lamp goes off.
Operation
Operation
91101983_A3