Electrical Connection; Electrical Requirements; Door Reversal - Saber K00AA3314 Guía Del Producto

Electrical Connection

WARNING
WARNING: Improper use of the grounded plug can result
in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
• This unit should be properly grounded for your safety. The
power cord of this unit is equipped with a three-prong plug
which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.
• Do not under any circumstances cut or remove the third
ground prong from the power cord supplied. For personal
safety, this appliance must be properly grounded.
• This unit requires a standard 115 Volt AC 15 amp /60Hz
electrical outlet with three-prong ground. Have the wall outlet
and circuit checked by a qualified electrician to make sure
the outlet is properly grounded. When a standard 2-prong
wall outlet is encountered, it is your responsibility to have it
replaced with a properly grounded 3-prong wall outlet.
• The cord should be secured behind the unit and not left
exposed or dangling to prevent accidental injury.
• The unit should always be plugged into its own individual
electrical outlet which has a voltage and power rating that
matches the rating label on the appliance. This provides the
best performance and also prevent overloading house wiring
circuits that could cause a fire hazard from overheating.
• Never unplug the unit by pulling the power cord. Always grip
the plug firmly and pull straight out from the receptacle.
• Repair or replace immediately all power cords that have
become frayed or otherwise damaged.
• Do not use a cord that shows cracks or abrasion damage
along its length or at either end. When moving the unit, be
careful not to damage the power cord.
Extension Cords
Because of potential safety hazards under certain
conditions, it is strongly recommended that you do not use
an extension cord with this unit.
Reversible Door Swing
This refrigerator can be opened either from the left or right
side. The default way of opening the door is from the left side,
with the hinges on the right side. If you want to open the door
from the right side with hinges on the left side, please follow
the instructions below.
1. Remove the top hinge pin screw located in the top hinge.
Keep pin screw to mount the door in the new hinge on the
opposite side location.
2. Remove the door from the lower hinge, and keep the
padded surface upwards to prevent scratching.
3. Remove the 3 screws that hold the top hinge on the
refrigerator. Keep screws to mount the new hinge on the
opposite side location.
4. Remove the 3 screws that hold the lower hinge on the
refrigerator. Keep screws to mount the new hinge on the
opposite side location.
5. Install the lower hinge provided in the hardware bag onto
the left side of the door opening using the 3 screws from
right side lower hinge.
6. Install the top hinge provided in the hardware bag onto the
left side of the door opening using the 3 screws from the
right side top hinge.
7. Install the door by locating it on the left side lower hinge
pin.
8. Position the door into the top hinge on the left side and
align the pin screw location. Insert the pin screw from the
right side into the door and secure.
9. Ensure the door is aligned properly to the refrigerator body
and swings level. Adjust hinges as needed to level the
door.
4