Briggs & Stratton Snapper Manual Del Operador página 9

2. That the extension cord is properly wired and in good
electrical condition; and
3. That the wire size is a minimum of 16 AWG to allow
for AC ampere rating of the charger.
• Do not operate the charger with a damaged plug or
cord. The supply cord cannot be replaced. If the cord is
damaged, the charger should be replaced immediately.
• Do not operate the charger if it has received a sharp
blow, been dropped, or otherwise damaged in any way. If
the charger is damaged it must be replaced. The charger
is not serviceable.
• Do not disassemble the charger; or attempt to service.
• To reduce risk of electric shock, unplug the charger from
outlet before cleaning.
• Do not short circuit; never place any object into the
battery contacts.
• The charger is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to make sure that they do
not play with the charger.
When To Charge The Battery Pack
First Time Portable Battery Pack - The Lithium‐Ion portable
battery pack was partially charged before shipment. To
maintain charge and to prevent damage while in storage,
the battery pack is programed to enter a "sleep mode". A
quick charge of approximately ten (10) seconds is required
to wake up the battery. Leave battery pack in charger until
fully charged. To charge the battery pack, see the How To
Charge The Battery Pack section below.
As Required - To check available charge, push the Battery
Fuel Gauge button (E, Figure 5 6) and charge if required. See
the Battery Fuel Gauge section.
5
6
How To Charge The Battery Pack
WARNING
Keep the battery charger dry. Avoid exposing the battery
pack to rain or wet conditions.
1. Connect the battery charger (F, Figure 7 8) to an
electrical outlet.
9