Dead Zone; Sensitivity; Force Effects Force; Force Effects Filter - FANATEC SPEED STER 3 Manual Del Usario

3.2.1 Dead Zone

Adjustment range: +3 to –9
The dead zone is the area around the central position of the
steering wheel within which a movement does not trigger a
reactionfrom the car in the game.
This area can be extended, or completely eliminated if you want
every steering wheel movement to immediately result in a reaction
by the car.

3.2.2 Sensitivity

Adjustment range: 0 to 5
This function determines the degree to which the car reacts to
a steering wheel movement in the game. With a setting of "4",
even a slight movement will cause the car to turn sharply.
At "0", you have to turn the steering wheel right round to
achieve the same turn.

3.2.3 Force Effects Force

Adjustment range: 0 to 3
The intensity of the Force Effects can be selected freely.
At "0", Force Effects is deactivated.

3.2.4 Force Effects Filter

Adjustment range: 0 to 4
The filter determines from when the Force Effects will be engaged.
The effects of engine vibration will then occur or only in the case
of a serious accident. "0" means that it is unfiltered.

3.2.5 Vibration (Shock)

Adjustment range: 0, 1, 2, 3
You can configure the degree of vibration of the two motors.
0 = off; 1 = 50%; 2 = 100%; 3 = 200%

3.2.6 Steering Resistance (Spring)

Adjustment range: 0 to 3
The intensity of the steering resistance determines the force that
is necessary to move the steering wheel.

3.2.7 Programming

The two hand levers can also be equipped with other functions.
Press on the hand lever that you want to change. Then press again
on the desired function (e.g. "B Button" key).
You can now reprogramme the next button or leave the
programming mode.
The functions of the pedals can also be changed. Some games
can be steered more accurately when the right mini joystick of
the Xbox Controller is used for accelerating and braking.
Press on the gas pedal in the programming mode and then
"STEERING COLUMN top". The gas pedal now has the function of
"right mini-joystick to the front". Then press on the brake pedal and
then "STEERING COLUMN bottom". The braking pedal now has
the function of "right mini-joystick to the back".
Similarly to the pedals, the hand levers can also be equipped with
other buttons.
If you want the original settings of the pedals again, then press
on the gas or brake pedal in the programming mode and hold
it down for about 5 seconds.
Please note that the key functions must be correspondingly
changed in the game!
15