Toyotomi Zibro RC-320 Instrucciones De Uso página 9

When you have ignited the heater and it shuts off again shortly after, the batteries
need to be replaced. It is best to use new alkaline batteries (4x D-size).
!
If the heater has been used only a few times and the wick adjustment knob is
not locked, first turn the wick adjustment knob (Fig. M) completely left, before
putting the wick in the highest position for ignition (Section C).
After having ignited the heater, always check whether the combustion
!
chamber  is level, by sliding it slightly to the left and the right by its handle
 (Fig. E). This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
d
BURNINg OF THE HEATER
After you have ignited the heater, it will take 30 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells.
✗
!
If the flame remains low after the adjustment, the wick height must be
adjusted (refer to Section F).
Burning that is too low may be caused by:
 insufficient fuel
 poor fuel quality
 insufficient ventilation
 wastage of the wick (contact your dealer or replace the wick, refer to Section M)
When there is insufficient ventilation in the room, an intermittent buzzer will be
heard and the VENT lamp (Yellow) will be lit. When this signal is given, ensure
that the ventilation of the room is improved (e.g. by opening a door or window a
little more) to avoid that the heater shuts off. When the ventilation of the room
is improved, the VENT lamp and buzzer will be deactivated. When there is still
insufficient ventilation, the heater shuts off automatically. After improving the
ventilation of the room (e.g. by opening a door or window a little more), the
heater can be ignited again.
!
This heater is fitted with a safety system that ensures that it switches off if you lift
the exchange tank out of the heater for more than 5 seconds. To switch the heater
on again, put the exchange tank back and follow the steps in Section C.
E
SWITCHINg OFF THE HEATER
Push the OFF-button . The flame will extinguish after a little while (Fig. N).
4
8
✓
(fill the tank)
(contact your dealer)
(put window or door ajar)
✗
 R
M
E
S