Instructions Before Installation - Dometic WAECO MagicWatch MWE820 Instrucciones De Montaje Y De Uso

MWE820, 860, 890
4

Instructions before installation

4.1 Determining the place of installation for the
sensors
See fig. 3 to fig. 6
NOTE
I
The sensors must be correctly aligned for the device to work prop-
erly.
If these point to the ground, irregularities and bumps on the surface
may be interpreted as obstacles. If they point too far up, obstacles
will not be detected at all.
Note the following during installation:
 The distance from the sensors to the ground should be 50 cm (fig. 3).
 For the sensors to function optimally, the angle of the sensor to the road
surface should be 90° (fig. 3). The angle may not be less than 90°, as
the road will otherwise be interpreted by the sensor as an obstacle.
 Observe the positioning of the sensors (fig. 4).
4.2 Painting the sensors
See fig. 2
NOTE
I
The sensors may be painted. The manufacturer recommends
having the sensors painted by a specialist workshop.
EN
Instructions before installation
19