Publicidad
Idiomas disponibles
Idiomas disponibles
11
For blade assembly, position blade holder (#6), blade (#7) so that all
screw holes are aligned (as shown in figure below). Using blade screws
(S4), insert through top of blade holder, through blade, and into blade
ornament. Tighten securely.
Blade Holder
Screws (S6)
CAUTION:
Install blade holders to motor only after motor installation is complete. This will
prevent damage to the blade holders which have been carefully balanced.
IMPORTANT: Remove rubber cushions, saving motor screws for installation.
12
5 Blade Installation
Remove rubber cushions, saving motor screws for blade installation.
Using motor screws (S5) provided, line up holes from the blade arm with
the holes in the motor housing. Tighten screws securely.
Step 11
Blade Screws (S4)
Blade (7)
Blade Arm (6)
Step 12
13
1. To install the Switch Housing Assembly (#8), locate both modular
wiring plugs (A) and (B). One extends from the mounting plate (E) on
bottom of fan body and one extends from the Switch Housing (#8). Align
the two plugs so the latch on the side of the plugs will engage when
pushed together. Push the two plugs firmly together until latched.
2. Locate switch housing screws (S9). Raise switch housing cover (#8)
and align the mounting holes with the holes on mounting plate (E). Once
the holes are aligned, attach the switch housing cover using the switch
housing screws (S9) and tighten firmly.
IMPORTANT: Be sure that no wires are caught in mounting slots or pinched between
switch housing and mounting plate.
Screws (F)
Mounting Slots (D)
CAUTION
To reduce the risk of personal injury, DO NOT bend the blade arms when
installing them. When balancing the blades, or cleaning the fan, do not insert
foreign objects in between rotating fan blades.
Step 13
Mounting Plate (E)
Modular Wiring Plug (A)
Modular Wiring Plug (B)
Switch Housing (8)
Publicidad
