Adding Extensions; Gate Placement; Wall Cups - Munchkin vibe MKSA0511-011 Guia De Instalacion

How To Install
See the extensions chart on page 6 for the proper extension confi guration for
your opening.

ADDING EXTENSIONS

If your opening is between 30 and 32.5 inches (76.2 and 82.5
cm) wide, you DO NOT need to add any extensions. Please
skip to the next section: Gate Placement. For openings wider
than 32.5 inches (82.5 cm), attach either the small or medium
extension (or both) before installation.
1. Pull out the TurnKey Mounts™ from the top and bottom corners of one side of
the gate and put them aside for now.
2. Insert the small extension into the pockets where you removed the
TurnKey Mounts™.
3. Re-insert the TurnKey Mount™ that you removed earlier into the open pockets
of the extension. Be sure to insert the TurnKey Mounts™ so that the hex head
in the mount is aligned with the hole on the gate frame.
4. To attach additional extensions, repeat the steps above on the other side of
the gate.
1 2
8

GATE PLACEMENT

This gate is approved for use at the top or bottom of stairs, as well as in
doorways, hallways and entryways. The gate must be installed between two
structurally sound surfaces.
If you are installing the gate at the top of stairs, it MUST be placed on the top
landing and only swing away from the stairs. Do not use this gate in any location
without using all 4 wall cups, sticky pads, and screws provided when installing
the gate.
If you are installing the gate at the bottom of the stairs, we recommend placing
it on the fl oor below the fi rst step. If the gate must be placed on the lowest stair,
position it toward the front of the step.
Be sure that the gate is resting on the floor. The gate should NOT be raised
above the floor >5mm.

WALL CUPS

3
1.
Do not use this gate in any location without using all 4 wall
cups, sticky pads, and screws provided when installing
the gate.
Temporarily place the gate where you want to install it.
How To Install
9