Publicidad
Idiomas disponibles
Idiomas disponibles
fresh tap water, boil and empty the kettle at least twice, to clear
the kettle of any small particles. Do not drink this water, though.
1. Pull the lock device on the lid backwards to open it;
2. Remove the kettle from the base and fill the kettle with the
desired amount of water (between the minimum and maximum
marks). Close the lid and replace the kettle on the base unit;
3.Putting the kettle on the base, display screen lit up (Nixie tube
show 100, two indicators lit up), and off when move the kettle.
4.NOTE: If not operate after put the kettle, screen will off after
10 seconds. Then press any button will let display start (Nixie
tube show 100, two indicators lit up).
5. Boiling Function
Putting the kettle on the base, all indicator lit up, press the button
of ON/OFF (the tube show 100), the indicator next button lit up
and flicker, heating tube start to work, the water will boil to
100±2゜C, the heating tube will stop to work ( the indicator off),
the tube keep 10 seconds working, the power will off after 10
seconds.
NOTE:
1) The temperature can be adjust during boiling, the water only
can to the temperature on the tube, then will stop heating.
2) The power should be off after 15 seconds when 98゜C.
6.Select 40-90゜C boiling:
a. Putting the kettle on the base, all indicator lit up, press the
button ON/OFF (tube show 100), the indicator next button lit
up and flicker, corresponding temperature button (up/down)to
arrive the temperature, when the tube start to work, the water
will boil to 40-90±4゜C, the heating tube will stop to work ( the
indicator will stop), The power will off after 10 seconds.
7.The temperature can be adjust during boiling, the water will
stop heating until the temperature arrived.
8.If the actual temperature higher than the setting, ON/OFF
button will lit up and flicker, but the heating tube will not work,
until it's down to the setting, the indicator will off, the tube keep
10 seconds then off.
Publicidad
