Key Automation CT202 24 Instrucciones Y Advertencias Para Su Instalación Y Uso página 30

EN
6 - FURTHER DETAILS - ADVANCED MENU
The ADVANCED MENU allows the system to be further customised
by modifying parameters not accessible from the basic menu.
To access the ADVANCED menu, press the MENU key and hold it
down for 5 seconds.
PARAMETS
SP.h.
1
Ph.2.
2
tP.h.
3
n
Ed.m.
4
iE.D.
5
tE.D.
6
LP.o.
7
TP.C.
8
FP.r.
9
tP.r.
10
FC.Y.
11
tC.Y.
12
de.a.
13
IN.D.
14
30
DESCRIPTION
Use of PHOTO1 when starting from closed
0 = PHOTO1 is checked
1 = The gate starts even with PHOTO1 excited
Use of PHOTO2
0 = Enabled during both opening and closing AP/CH
1 =Only enabled during opening AP
Photo-device test
0 = off
1 = PHOTO1 on
2 = PHOTO2 on
3 = PHOTO1 and PHOTO2 on
STOP/EDGE input selection
0 = STOP contact (NC)
1 = Resistive safety edge (8k2)
2 = Contact safety edge (NC)
Sensitive edge tripping mode
0= only tripped during closure with direction reversal
1 = stops the automation (during both opening and closure) and
retreats from the obstacle
Edge test
0 = off
1 = on
Partial opening
Time for automatic closure from partial opening (0=off)
Flashing light output setup
0 = Steady
1 = Flashing
Pre-flashing time (0 = off)
Courtesy light setup
0 = On at end of operation for time TCY
1 = On if gate not closed + duration of TCY
2 = On if courtesy light timer (TCY) time not out
Courtesy light on time
Hold-to-run
0 = off
1 = on
0 = deactivated
1 = gate open light ON/OFF
2 = gate open light proportional
- Slow flashing with gate opening
- Quick flashing with gate closing
- Steady light if gate open
- 2 flashes + pause with gate stationary (position other than closed)
3 = Electric lock
4 = Magnetic electric lock function with output active when gate/door
is closed
N.B. interface with an external relay with 24 Vdc winding. To activate
this function, the pre-flash must be enabled at the recommended
value of 1 sec (tP.r. ≠ 0)
To modify ADVANCED MENU parameters, proceed as described
for the BASIC MENU.
N.B. Some default functions/display items may vary with respect to
the type of motor selected.
DEFAULT MIN
50
MAX UNIT
1 0 1
0 0 1
0 0 3
0 0 2
0 0 1
0 0 1
0 100
0 0 900
1 0 1
0 0 20
0 0 2
0 0 900
0 0 1
0 0 4
%
s
s
s