Nolan N100E Seguridad E Instrucciones página 15

CHECKING AND ADJUSTING THE INNER VISOR AIR DRAUGHT
Check for correct system fitting, by opening and closing the visor and check that both
visors are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simul-
taneously upwards to increase the air draught (Fig. 15). This operation must be carried out
gradually. The maximum air draught is achieved when the external levers for the pin adju-
stment are turned outwards.
WARNING!!!
The presence of dust between the visors can produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
changed.
Regularly check the correct air draught of the inner visor to prevent the same from moving
and scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both for
system correct fitting and air draught.
An excessive and early air draught of the inner visor may result in excessive adherence
against visor surface and/or permanent deformations with subsequent inability to perform
following adjustments correctly.
The extended use in special weather conditions may reduce system performance and
result in partial fogging and problems of condensation on the inner visor. In this case,
remove the inner visor from the helmet visor and dry it with dry and lukewarm air.
2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor and unhook the inner visor from the pins Fig. 14.
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it with
neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a
ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
VISION PROTECTION SYSTEM (VPS)
The new and exclusive Vision Protection System (VPS) is aAAAAAAmoulded, antiscratch-
treated sunscreen positioned on the outside of the visor. Using it is very simple and prac-
tical: just pull it down or up to activate/exclude it from the field of vision. Useful in all sorts
of situations, whether it's on long journeys out of town, or shorter trips about town. The
innovative rotating mechanism – synchronized with the opening of the visor– ensures per-
fect functioning in all riding conditions. The VPS is easy to remove when it is not needed,
or for normal maintenance and cleaning operations.
VPS operation
The VPS is positioned on the outside of the visor and its operating mechanism has been
conceived to ensure that the sunscreen remains precautionary open when using the visor
15