Troubleshooting Guide - Bostitch BTC440 Manual De Instrucciones

REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to
order parts, visit our service website at www.BOSTITCH.
com. You can also order parts from your nearest BOSTITCH
Factory Service Center or BOSTITCH Authorized Warranty
Service Center. Or, you can call our Customer Care Center at
(800) 556-6696.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or
replacement of parts. For information about BOSTITCH,
its factory service centers or authorized warranty service
centers, visit our website at www.BOSTITCH.com or call our
Customer Care Center at (800) 556-6696. All repairs made
by our service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee repairs
made or attempted by others.
You can also write to us for information at BOSTITCH, 701 E.
Joppa Road, Towson, Maryland 21286 - Attention: Product
Service. Be sure to include all of the information shown
on the nameplate of your tool (model number, type, serial
number, etc.).

Troubleshooting Guide

BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
For assistance with your product, visit our website at www.BOSTITCH.com for a list of service centers, or call the BOSTITCH
Customer Care Center at (800) 556-6696.
PROBlEM
- Unit will not start.
- Battery pack will not charge.
- Unit shuts off abruptly.
ACCESSORIES

WARNING: Since accessories, other than those
offered by BOSTITCH have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only BOSTITCH
recommended accessories should be used with
this product.
A complete line of accessories is available from your
BOSTITCH Factory Service Center or a BOSTITCH Authorized
Warranty Service Center. Please visit our Web Site www.
BOSTITCH.com for a catalog or for the name of your
nearest supplier.
Lubrication

WARNING: NEVER spray or in any other way apply
lubricants or cleaning solvents inside the tool. This can
seriously affect the life and performance of the tool
and may result in personal injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
POssiBlE CAUsE
- Battery pack not
installed properly
- Battery pack not charged.
- Battery pack not inserted
into charger.
- Charger not plugged in.
- Surrounding air temperature
too hot or too cold.
- Battery pack has reached its
maximum thermal limit.
- Out of charge. (To maximize
the life of the battery pack it is
designed to shut off abruptly
when the charge
is depleted.)
English
POssiBlE sOlUTiOn
- Check battery
pack installation
Check battery pack
charging requirements.
- Insert battery pack into
charger until LED illuminates.
- Plug charger into a working
outlet. Refer to Important
charging notes for
more details.
- Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
- Allow battery pack to
cool down.
- Place on charger and allow
to charge.
9