Adjustment Of The Powerstapler; Springs Adjustment - Hupfer Powerstapler PSUH Manual De Instrucciones

Section 5
Page 18
5.2

Adjustment of the Powerstapler

WARNING
The adjustments may only be carried out on appliances which are switched off, disconnected from the power
supply and cooled down (room temperature).
Before work starts, it is always necessary to check whether the Powerstapler is adjusted correctly for the
items to be used.
Control the dispensing height to prevent the staff from suffering injury or become trapped and to prevent
breakage of crockery can occur.
Basically, the appliance must be adjusted if at least one of the following parameters changes:
§
Diameter
§
Height
§
Stack height
§
Weight
5.2.1

Springs Adjustment

CAUTION
CAUTION
Before loading the appliance, the dispensing height must be adjusted to the type of crockery used. The dis-
pensing height is adjusted by attaching or detaching tension springs. As long as the same kind of items is
always used, the dispensing height only needs to be set once.
Step 1 – Check the adjustment of the springs
§
Place a stack of heat-retaining base parts on the stacking platform to test the dispensing height.
§
Wait for the system to self-adjust.
If the stack drops down only a little or not at all, the dispensing height must be altered by adjusting the
springs.
Powerstapler
PSUH
Hazard caused by hot surfaces
The internal surfaces of the heated appliances and the base plates can be-
come hot during use and cool down slowly in the air.
To adjust the stacking platform, allow the appliance to cool down sufficiently
with open covers.
Personal and property damage due to improper adjustment
When the dispensing height is exceeded, there is a risk of accident or injury
due to tipping of the inserted stacks. If the level of the stack falls below the
dispensing height, fingers may be injured if caught when removing dishes.
Adjust appropriately the dispensing height by attaching or detaching the
springs. When adjusting springs on sharp edges, pay particular attention to
the ends of the tension springs. Proceed with care.
Risk of injury
Be careful when attaching and detaching the springs.
Pay particular attention to the ends of the tension springs when adjusting
springs on sharp edges.
Operation
Adjustment of the Powerstapler
91346811_A1