Hupfer Powerstapler PSUH Manual De Instrucciones página 48

Operation
Adjustment of the Powerstapler
Step 2 – Change the adjustment of the springs
The dispensing height is adjusted by attaching or detaching tension springs on four attachment bars. The
springs are arranged in groups of five, where one is a base spring with higher tension (1) and four are ad-
justable springs (2) with lower tension.
Figure 4
If the dispensing height is too high, adjustable springs must be detached. If the dispensing height is too low,
adjustable springs must be added.
Procedure for adjusting the springs:
§
Remove inserted stacks from the stacking platform (if available).
§
Attach or detach adjustable springs evenly in all groups of springs.
§
It is best to detach the adjustable springs. Always leave the base springs inserted, if possible. Always
detach the springs on the lower attachment bar.
As long as the same kind of items is always used, the dispensing height only needs to be set once.
NOTE
NOTE
91346811_A1
Attachment bar with tension springs (example)
Arrangement of the springs
The springs need to be in a symmetrical arrangement between the attach-
ment bars to ensure that the stacking platform is guided smoothly and steadi-
ly.
A slightly asymmetrical arrangement of springs within an attachment bar does
not pose a problem.
Spring system
Since Powerstapler are designed for a maximum load, the available spring
system of the appliances is entirely sufficient for all usual stack items.
Section 5
Page 19
Powerstapler
PSUH