Beater To Bowl Clearance; Using Your Stand Mixer; Mixing Time; Mixer Use - KitchenAid KSM7586P Manual De Instrucciones

Beater to Bowl Clearance

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom
of the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far
away from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer.
2. Place bowl-lift lever in down
position.
3. Attach flat beater.
4. Adjust so flat beater just clears
bottom surface of bowl when in
lifted position by turning screw (A)
counterclockwise to raise the bowl
and clockwise to lower the bowl.
Just a slight turn is all that is
required: the screw will not rotate
more than 1/4 turn (90 degrees)
in either direction. (The full range
of adjustment is 1/2 turn, or 180
degrees.)
5. Place bowl-lift lever in up
position to check clearance.
6. Repeat steps 4 and 5 if necessary.

Using Your Stand Mixer

Mixing Time

Your KitchenAid
faster and more thoroughly than most
other electric stand mixers. Therefore,
the mixing time in most recipes must

Mixer Use

NOTE: Do not scrape bowl while
Stand Mixer is operating.
8
Stand Mixer will mix
®
Raise Bowl
A
NOTE: When properly adjusted, the flat
beater will not strike on the bottom or
side of the bowl. If the flat beater or the
wire whip is so close that it strikes the
bottom of the bowl, coating may wear
off the beater or wires on whip may wear.
be adjusted to avoid overbeating. With
cakes, for example, beating time may be
half as long as with other stand mixers.
The bowl and beater are designed
to provide thorough mixing without
frequent scraping. Scraping the bowl
once or twice during mixing is usually
sufficient. Turn Stand Mixer off before
scraping. The Stand Mixer may warm
up during use. Under heavy loads with
extended mixing time, you may not
be able to comfortably touch the top
of the Stand Mixer. This is normal.
Lower Bowl