Problem
A layer of frost occurs in food is placed within the appliance to allow sufficient
the compartment
Temperature inside is
too warm
Temperature inside is
too cold
Doors cant be closed
easily
Water drips on the floor
The light is not working
FAULT DISPLAY
Fault display shows as following under Fault mode:
FAULT MODE
Ref sensor Fault
Room sensor Fault
Trans-temp sensor Fault
No-frost sensor Fault
Freezer sensor Fault
Correspondence Fault
Fan Faul
The LED bead from control panel shines at 1 HZ under fault mode, when closing door,
the lamp is off and when opening door, the lamp is on. Once the control panel fails to
examine the fault, the lamp will stop shining ri g ht away.
Possible cause & Solution
Check that the air outlets are not blocked by food and ensure
ventilation. Ensure that door is fully closed. To remove the
frost, please refer to cleaning and care chapter.
You may have left the doors open too long or too frequently; or
the doors are kept open by sorne obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
lncrease the temperature by following the "Display controls"
chapter.
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close, or if something inside
is preventing the doors from closing.
The water pan (located at the rear bottom of the cabinet) may
not be properly leveled, or the draining spout
underneath the top of the compressor depot)
properly positioned to direct water into this pan, or the water
spout is blocked. You may need to pull the refrigerator away
from the wall to check the pan and spout.
•The LED light may be damaged. Refer to replace LED lights
in cleaning and care chapter.
•The control system has disabled the lights due to the door
being kept open too long, clase and reopens the door to
reactivate the lights.
22
FAULT DISPLAY
lndicator 1 shines
lndicator 2 shines
lndicator 3 shines
lndicator 4 shines
lndicator 5 shines
Both lndicator 1&2 shine
Both lndicator 1&3 shine
( located
may not be
V.2