Replacing The Batteries - Arregui PLUS C Manual De Instrucciones

<EN>
6. USING THE EXTERNAL BATTERY FEED
To carry out an opening with the external feed, proceed in the
following manner:
• Place 4 x 1,5V (AA) batteries in the external feed.
• Insert the feed connector in the current outlet located on
the lower left of the keypad. The box will emit a long beep,
indicating that it has a feed connection. Do not remove the
feeder until the opening procedure has been completed.
• As soon as "--------"shows on screen, open the box according
to section 2.
Should you not have an external AA battery feed to hand that
ARREGUI provides, you can use any external lithium battery
with a micro USB connector.
7. INDICATORS OF THE STATE OF THE
BATTERY
Each time the key is tapped to go ahead with using the
safe, the electronic system checks the state of the batteries. If
the batteries are at a high level, the box will function normally.
If on the other hand the batteries are low, the box will display
the "LO-BAT" message on screen. The box is designed to be
able to carry out several openings even when the batteries
are low, but even so ARREGUI recommends changing the
batteries as soon as the box indicates it is necessary.
If you wish to find out the state of the batteries, you may tap
the enter key with the box switched off; the system will
carry out checks on the condition of the batteries, and will
display the "HI-BAT" sign if the battery levels are normal, and
"LO-BAT" if it is low.

8. REPLACING THE BATTERIES

Open the box in accordance with Section 2 or Section 5, and
take off the lid of the battery carrier stored on the inside of
the door. Replace the installed batteries with 4 new alkaline
Batteries, of type 4 1,5V (AA).
9. KEY COPYING
The Plus C safe comes with two user keys. If it is necessary
to make further copies, you should get in touch with an
authorized distributor, with one of the available keys, and the
ARREGUI safe owner card which comes with the safe.