Troubleshooting - Honeywell Home Smart Serie Guia Del Usuario

Troubleshooting

Lost Signal
If the no-Wi-Fi indicator displays in place of the
Wi-Fi strength indicator in the upper right hand
corner of the home screen:
• Check another device to be sure Wi-Fi
is working in your home; if not, call your
Internet Service Provider.
• Move the router.
• Restart the thermostat: remove it from
the wallplate, wait 10 seconds, and snap it
back onto the wallplate. Return to Step 1 of
Connecting to your Wi-Fi network.
Error Codes
For certain problems, the thermostat screen will display
a code that identifies the trouble. Initially, error codes
are displayed alone in the time area of the screen; after a
few minutes, the home screen is displayed and the code
alternates with the time.
Error Code
E01
During Wi-Fi Setup, the router
lost power.
E02
Invalid Wi-Fi password. This
code displays for 30 seconds,
then the thermostat will re-
enter Wi-Fi Setup mode.
Error Code
E42
Router is not issuing
an IP address to the
thermostat.
E43
No internet
connection.
Thermostat cannot
communicate to Total
Connect Comfort.
E99
General error
Action
• Ensure your router has power.
• If trying to connect to a hidden or manually added network,
confirm the router has power and is working.
• Re-enter password for your home Wi-Fi network.
• Repeat setup process and confirm your password for your
home Wi-Fi network.
Action
• Wait for 30 minutes, connection can
take several minutes.
• If still no connection, remove
thermostat from wallplate for 10
seconds, then reconnect it (see page
10).
• Verify your router is correctly setup
to automatically give IP addresses.
• Make sure the Internet cable is
plugged in.
• Reboot the router.
Remove thermostat from wallplate
for 10 seconds, then reconnect it (see
page 10).
21
M33997 M33997
M33999
M33998
69-2715EF—07