Unpacking Instructions - Fanimation The Islander FP3201 Serie El Manual Del Propietario

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 20, page 13)
• Fan Motor assembly
• Downrod/Hanger Ball assembly
• Blade Holder pack containing:
– Five blade holders (Side A)
– Five blade holders (Side B)
• Ceiling Canopy
• Hanger Bracket
• Hardware bag:
– Ten 10-32 x 1/2˝ (blade holder to fan
motor assembly) screws
– Two 5/32˝-32 x 19 mm threaded rods
– Two 5/32˝ lockwashers
– Two knurled knobs
– Three wire connectors
– Fanimation pull chain
• Motor Coupling Cover
• Blade Mounting Hardware Bag
– Ten 3/16˝-24 x 1/2˝ screws (for use with
Side A and Side B of the blade holder)
– Fanimation screwdriver
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
DAMP LOCATION CEILING FAN: If you have purchased a
Damp Location Ceiling Fan, you may only use light kits marked
suitable for use in damp locations.
Side A
Hardware Bag
Upper Foam
Packing
Lower Foam
Packing
3
Wire Size A.W.G.
14
12
Side B
Downrod/
Hanger Ball
Ceiling Canopy/
Hanger Bracket
Blade Mounting
Hardware Bag
Motor Coupling
Cover
Fan Motor
Assembly