Fan Assembly. Pgs - Craftmade ELLINGTON COL72BP6 Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
downrod provided, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of longer downrod
and raise hanging ball. Be sure stop pin aligns
with slots on the inside of the hanging ball.
Tighten set screw securely. (diagram 1)
Remove blade arm screws and lock washers from
underside of motor in order to remove blue motor
stabilization plate. Blue motor stabilization plate
may be discarded once removed. (diagram 2)
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor housing.
Remove pin and clip from motor housing yoke.
Slide downrod through canopy, canopy cover and
yoke cover. [Note: Canopy cover must be turned
with shiny side toward the motor housing.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod. (diagram 3)
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
diagram 1
stabilization
plate
diagram 2
electrical wiring
downrod
canopy
yoke cover
clip
diagram 3
page 4
set screw hole
stop pin
hanging ball
safety cable
canopy cover
yoke set screw
and nut
pin
motor housing