Tv Program And Audio Selection - Alcad 905-TO Serie Manual De Instrucciones

7. TV PROGRAM AND AUDIO SELECTION

Once COFDM channel data are transmitted, the transmodulator will show
the following message TUNING CHANNEL... After tuning the channel it
will show SEARCHING LIST... message, showing the TV programme
and audio list of the channel.
By selecting
Programs List
keys, you will be able to move through the program list shown on the OSD.
This way, the program shaded is selected, and is seen on the OSD menu.
Therefore, the shadowed program will be the selected one and it could be
watched behind the OSD menu.
By selecting
Audio List
you will be able to move through the audio list shown on the OSD. This way,
the audio shaded is selected, and is seen on the OSD menu.
By selecting Output format in the PS programmer and press the T key;
the TV image format submenu will appear in the OSD. Using the & an '
keys, you can select the desired format from those shown in the menu: the
highlighted option is the one which is selected. When you press the T key
again, the output format menu disappears.
WARNING: This submenu is only effective when the programme received
is in the 16:9 format.
By selecting
Invert Dual
could switch between the audio carriers from A-B to B-A. This inversion will
be displayed in the OSD menu. In a mono TV, the listened audio carrier, will
be B.
Serie 905-TO
on the PS programmer, using & and ' keys,
PARAMETERS:
1-OUT.CH : C21 BG
2-INP.CH : C60 BG
OUTPUT FORMAT (PROGRAMS 16:9)
3-OFFSET : Aut:0
LETTER BOX 4:3
4-BW : 8MHz
FULL SCREEN 16:9
Firmware v 1.0d
BER: 2.3E-3
Fig. 10 - Output format
on the PS Programmer, using & and '
PROGRAMS: (5)
01-FTA-TVE 2-----------TV
02-FTA-ANTENA 3--------TV
03-FTA-TELECINCO-------TV
04-FTA-TVE 1-----------TV
AUDIO: (1)
01-ESP
in the PS programmer and pressing T, you
ENG - 31
DUAL A-B