Operating Instructions; Using Ellison® Surecut™ Dies - Ellison SuperStar Excel Manual De Instrucciones

4. Operating Instructions

See Die and Accessory Compatibilty Table on page 12
Sliding Adapter Pad
Extended Sliding Tray
SureCut Dies
1. Place a SureCut die, with the foam side up, directly onto the extended
sliding tray. Make sure the Sliding Adapter Pad is moved to the other side (out
of the way) when cutting with SureCut dies.
2. Place paper (or compatible material*) to be cut on top of the die.
3. Place an appropriately sized cutting pad on top of your cutting material
and die.
4. Carefully push the extended sliding tray into the opening of the SuperStar
Excel machine until the cutting pad contacts the roller.
WARNING
5. Note the rotation of the crank handle and continue to rotate it in the same
direction until your die, material and cutting pad have passed completely
through the rollers in either direction.
6. Remove your finished die-cut shapes and scrap material, and repeat as desired.
* A list of recomended compatible materials for use with the SuperStar Excel can be
found in the Materials guide on page 11.
SureCut
Figure A
Pinch and cutting hazard. Keep hands, fingers
and clothing away from contact with rollers
and dies while in use.
6
Cutting Pad
Material
Die
(Foam Side Up)