Starting Up; Maintenance And Care - Parkside PDMH 4500 A1 Instrucciones De Utilización Y De Seguridad

Anleitung_LB5_4139034:_
Performance values of the compressor:
The compressor used should have a tank
volume of at least 50 liters and a motor rating of
approx. 2.2 kW.
Setting values for work with the suction
spray gun:
Set a maximum working pressure of 6.3 bar at
your compressed air supply.
7. Starting up (Fig. 3)
Screw the supplied nipple (4) into the air
connection after you have wound 2-3 layers of
sealing tape around the thread. Plug the
required chisel into the hexagon mount of the
chisel hammer. Slip the tensioning spring (5)
over the chisel. Turn the tensioning spring onto
the thread of the cylinder (1) as far as the stop.
As you do this, hold the tensioning spring by the
front arm.
Connect the chisel hammer to a compressor or
compressed air network with matching power.
Do this with a flexible compressed air hose
(Ø 10 mm internal) with quick-lock coupling.
Make sure that the air regulation screw (3) is
adjusted so that air can flow through. Move the
chisel hammer towards the object you want to
work on. Actuate the trigger lever (2) to start the
chisel hammer.
To change the chisel you must first disconnect
the equipment from the compressed air source.
Turn the tensioning spring off the cylinder of the
chisel hammer by holding it by its rear arm. The
chisel can now be changed as described
above.
The chisel shaft should be lubricated with a little
normal lubricating grease from time to time.
13.04.2011 13:50 Uhr Seite 43

8. Maintenance and care

Important: Disconnect the equipment from the
compressed air supply before you carry out any
maintenance or cleaning work.
Compliance with the maintenance instructions
listed here will help this quality product provide
you with a long service life and trouble-free
operation.
Clean the equipment thoroughly and
immediately each time after it has been used.
Regular lubrication is essential for your chisel
hammer to work properly for a prolonged period
of time. Use only special compressed air oil as
supplied. Special compressed air oil is also
available from your dealer.
Note: Use environmentally friendly
compressed air oil if you want to operate the
equipment outside the workshop.
The following lubrication options are available:
8.1 Lubrication by mist oiler
Connect a complete conditioning unit with mist
oiler between the compressed air source and
the chisel hammer. A conditioning unit is
available from your dealer. It is not included in
the scope of this delivery.
8.2 Lubrication by hand
Each time before using the compressed air tool
insert 3-5 drops of special compressed air oil
into the compressed air connection. If the
compressed air tool has not been used for
several days you must insert 5-10 drops of
special compressed air oil into the compressed
air connection before switching on. Store your
compressed air tool only in a dry room.
8.3 Other maintenance
There are no parts inside the equipment which
require additional maintenance.
GB/
MT
43