Autoadapt Turny Evo Manual De Instalación página 38

38
Turny Evo Getting seated
2
Install the cross beams according to the instructions that are relevant below. Then adapt
the L-profile bracket or cross beams based on the option which is relevant on the previous
page. Loosen the L-profile bracket from the application tool if it is to be adapted.
OEM floor attachment
OEM quick attachment
OEM rail
Adapted
Option 1 = 11 mm
Option 2 = 9 mm
Adapted
Drill holes into the cross beam in the dimen-
sions which are adapted for OEM seat attach-
ment. Use OEM screw.
Drill holes into the cross beam in the dimensions
which are adapted for the wire lock. The wire lock
must in turn be adapted for OEM seat attachment.
Wire lock with M12 and M10 thread is
available to buy as an option. Contact
Autoadapt Support for further help.
Make a washer that can be slid into the relevant
rail. The washer must be 8 mm thick and have
threaded holes. Use washer for the screw.
Option 1
1 x M10
Option 2
2 x M8