Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT A QUALIFIED SERVICE
DEALER.
PROBLEM
The handle is not
in position.
The snow thrower
does not start.
The motor is on, but The belt is damaged.
the impeller does
not turn.
The snow thrower
leaves a thin layer of
snow behind.
TROUBLESHOOTING
POSSIBLE CAUSE
The bolts are not properly
seated.
Handle knobs not tightened.
The battery is not charged.
The switch is defective.
The battery is not attached to
the motor.
Battery may require service or
replacement.
The scraper is worn.
SOLUTION
Adjust the height of the handle, and verify
that the carriage bolts are properly seated.
Tighten the knobs.
Charge the battery.
Replace the switch. (Call the tollfree
helpline, at 1-888-266-7096)
Check the connection between the motor
connector and the battery.
Call toll free helpline, at 1-888-266-7096
or replace battery.
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
Replace the scraper (see the section
entitled Replacing the Scraper).
13 — English
Publicidad
Tabla de contenido
