Craftsman 138.88784 Manual Del Operator página 5

40 v 508 mm 20 pulg.
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS
• Always remove battery pack before storing
the device. When battery becomes fully
charged, unplug the charger from the power
supply and remove the battery pack from the
charger.
• Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure
to do so could result in objects being thrown
into your eyes and other possible serious
injuries.
• Keep battery pack dry, clean, and free from
oil and grease. Always use a clean cloth
when cleaning. Never use brake fluids,
gasoline, petroleum-based products, or any
solvents to clean battery pack.
PROPER CARE FOR BATTERY
Off-season storage
To obtain the longest possible battery life, we
suggest the following:
• Remove the battery pack from the charger
once it is fully charged and ready for use.
For battery pack storage longer than 30
days:
• Store the battery pack where the temperature
is below 80°F and away from moisture.
• Store battery packs in a 30%-50% charged
condition.
• Every six months of storage, charge the pack
as normal.
CHARGER SAFETY RULES
• DO NOT ABUSE THE CHARGE CORD.
Never carry the charger by the cord.
• Do not use a damaged charger. Replace the
charger cords or the charger immediately.
• Keep the charger away from water, heat
sources (radiators, heaters, stoves, etc.),
flames, and chemicals.
• Make sure the battery pack is secured in the
charger before beginning operation.
• The battery pack will become slightly warm
to the touch while charging. This is normal
and does not indicate a problem.
• Do not place the charger and battery pack
in an area of extreme heat or cold. They will
work best at normal room temperature.
• When batteries become fully charged,
unplug the charger from the power supply
and remove the battery pack.
WARNING!
When transporting or servicing unit, always
remove the battery.
PROPOSITION 65
WARNING!
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains chemicals
known to cause cancer, birth defects or
other reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints
• crystalline silica from bricks and cement
and other masonry products
• arsenic and chromium from chemically-
treated lumber
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as dust masks that are specially
designed to filter out microscopic particles.
5 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido