Installation; Instructions For Wall-Mounting - Euronda COMPACT 15 Manual De Instrucciones

The COMPACT negatoscope has been tested and inspected in the factory.
This instrument does not create electromagnetic interference with other devices.
Remove the packing and install the instrument observing the following instructions:
1. Position the negatoscope on a flat surface or on the wall.
2. Do not install the machine close to a sink or similar to avoid contact with water and possi-
ble electrical short circuits.
3. Keep the machine far from heat sources
4. Ensure that the electrical cable is not folded up and freely reaches the electrical socket.
5. Connect the supply cable socket to the negatoscope recessed plug, and then connect the
plug to the mains: the instrument is now ready for use.
6
PART 2

INSTALLATION

INSTRUCTION FOR WALL MOUNTING
Rear hinges
A
1. Drill two holes in the wall,
keeping "A" distance between
centres.
COMPACT 15: A = 291 mm
COMPACT 30: A = 200 mm
Use a suitable dowel, depend-
ing on the type of wall (cement,
brick, etc.).
2. Rest the negatoscope against the
wall in order to insert the two
screw heads into the appropriate
Ø 7 holes in the rear hinges.
3. Gently slide the negatoscope
downwards, until it locks into
position.
COMPACT