Broan best heater Manual De Usuario página 4

OPERATION
Controls
The hood is operated using the (4) push-but-
tons located at eye-level, on the front edge of
the hood.
The light switch turns the halogen lights on
and off.
The blower on-low / off switch turns the blower
on to its lowest running speed. The blower
must be turned on using this switch. Turn the
blower off by pressing this switch a second time.
The blower medium speed switch changes the blower speed to medium. This
switch works only if the blower is already running at low or high speed.
The blower high speed switch changes the blower speed to high. This switch
works only if the blower is already running at low or medium speed.
The pilot lamp lights up whenever the blower is on.
Heat Sentry
TM
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is
turned OFF. When this occurs, it is impossible to turn the blower OFF with its
switch. If you must stop the blower, do it from the main electrical panel.
HALOGEN BULBS
This range hood requires two or four halogen
bulbs (Type JC, 12V, 20W, G4 Base).
To change bulbs:
1. Open the light lens by grasping the tab on
the lens and rotating lens downward.
2. Remove the bulb by pulling sideward (Do
not rotate). CAUTION: BULB MAY BE HOT!
3. Do not touch replacement bulb with bare
hands! Push bulb securely into lamp socket
and snap lens closed.
LIGHT
SWITCH
BLOWER
ON-LOW /
SWITCH
LIGHT LENS
- 4 -
BLOWER
MEDIUM
SPEED
BLOWER
HIGH
SPEED
OFF
PILOT
LAMP
0
TAB