Fein KBM80U Manual Del Usaurio página 16

3 41 01 126 21 0.book Seite 16 Donnerstag, 21. Januar 2010 1:48 13
en
16
Working instructions.
Secure the power tool with the clamping strap supplied if there is danger of it fal-
WARNING
ling, especially for work carried out at a height, on vertical construction elements
or above the head. If there is a power cut, or the mains plug is pulled out, the
magnetic holding power is not maintained.
For switching the magnet ON (Fig. 9).
Please make sure that the contacting sur-
face for the magnetic foot is level, clean
and rust-free. Remove any varnish or primer.
When working, always use the magnetic
foot; pay attention that the magnetic hol-
ding power is sufficient:
– When the red warning light in the button of
the control panel is not lit and when the
main switch in the drill stand is lit perma-
nently, the magnetic holding power is suffi-
cient and the machine can be operated with
automatic feed.
– When the red warning light in the button of
the control panel and the main switch flash,
the magnetic holding power possibly is
insufficient and the machine must be opera-
ted with manual feed.
When working on materials that are not mag-
netizable, suitable fixation devices, obtainable
as accessories from FEIN, e. g. suction plate,
vacuum plate or pipe-drilling device must be
used.
When work on steel materials with a material
thickness of less than 12 mm, the workpiece
must be reinforced with an additional steel
plate in order to guarantee the magnetic hol-
ding power.
The magnetic foot is monitored by means of
a power sensor. If the magnetic foot is defec-
tive, the motor will not start.
Press the main switch to start the
machine.
Main switch
=
Clamping strap
Fig. 9