Special Functions; Important Notice - Eden 901 Instrucciones

GB
PROGRAMMING
Programming is easy and intuitive and is divided into two phases: time setting and feeding setting during
the day with the number of rations for each feeding. Ration means the quantity of food distributed from a
single rotation of the food container.
Setting of time:
- After the batteries have been inserted, the display time shows 00:00 with
hours blinking,
- Adjust current time with + and – and then press SET to store.
- Minutes blink, adjust with + and – and then press SET to store.
- The two dots will blink and the clock starts to work.
- To set time at a later moment press + and – simultaneously.
Programming of feedings:
Very important notice! On purchase the feeder is already pre-programmed:
Two standard feedings a day with one single ration at 8.00 o'clock and 18.00
o'clock. If this is sufficient for your fish no additional programming is required.
If more or different options are needed please proceed as follows:
- Press SET for 3 seconds (long press).
- The first digit will show the number of programmed feeding (1) whereas
the last digit will show a blinking 0. This digit is the number of rations for each
feeding.
which have to be set by pressing + or –, from a min. of 0 (no feeding) and a
max of 3 rations. Then press SET to store.
- Then time will appear to program the feeding time. Proceed as indicated
above : Set time, hours and min.
nd
- Now the first feed is programmed and the first digit will show nr. 2, that is to say the 2 feed to program,
whereas the last digit will show a blinking 0.
th
- Repeat same feeding procedure until the 4 feed is programmed. After this operation the two dots of
clock will blink, to indicate programming is concluded.

SPECIAL FUNCTIONS

- Button SET, if pressed shortly, allows the manual feeling and can be used to give
an additional feeling or to check the right quantity of food over a paper sheet
before placing it over the tank.
- By pressing SET and + simultaneously, the display will show the counter of the
total feeds.
- By pressing SET and – simultaneously display will shows nr. of programmed
feeds in form of horizontal segments (see example picture on the side).

IMPORTANT NOTICE

- After replacing of the batteries it is necessary to re-program only the clock.
- Do not use rechargeable batteries as this could damage the unit.
7