Transportation Requirements; Instructions For Use; Cooling - BALAY 3XM400B Instrucciones De Uso

Requirements for use
Warning!
The mains electricity supply connection
cable must only be replaced by
authorised members of the
manufacturer's Official Technical
Service.
When the appliance is turned off and
then turned back on, it takes the
compressor 3 minutes to start up again.
This period of time is required in order
to ensure correct operation.
Avoid direct contact with the air
expelled through the expulsion tube.

Transportation requirements

The appliance is fitted with wheels to
make it easier to move around. If
necessary, you can tilt the appliance in
order to move it. You should not turn the

Instructions for Use

Cooling

When set to position
cools and dehumidifies the air in the room
at the same time in order to create a
pleasant atmosphere.
• Plug the appliance into the mains
electricity supply.
• Lead the hot air expulsion tube outside.
In order to avoid excessive noise and
efficiency loss, the air expulsion tube
should be positioned as shown in,
Fig. 14. See "Temporary installation".
• Check that the plug, Fig. 1, is fitted on
the drainage pipe to prevent water from
leaking onto the support surface.
• Lift the air director on the top of the
appliance. This air director is not
, the appliance
39
appliance back on again for a minimum
period of one hour after performing this
procedure.
• Before tilting it, empty the condensed
water from the internal tank by extracting
the water drainage pipe from its housing
and removing the plug, Fig. 7, Do not
forget to replace the plug and reinser t
the pipe in its housing when the tank is
empty.
Fig. 7
installed on the appliance on 3XM411E
models. See figures 2 5 and 2 6 in "H e a t i n g".
• Select the maximum
cooling function, Fig. 8. (The silent
cooling function reduces the air flow on
the appliance).
• Set the thermostat to the desired
temperature, Fig. 9. If the appliance
Fig. 8
or silent