Bumper Bar; Fall Hazard; Safety - BABYTREND JG57 Manual De Instrucciones

ASSEMBLY

BUMPER BAR

WARNING:
Do not use
bumper bar to carry seat with
child inside. The bumper bar is
not a carrying handle.
10) • Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it locks into place (Fig. 10a).
Note: The bumper bar must be securely
attached before using this product.
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar out
to access the seat (Fig. 10b).
7
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
BRAKES
Fig. 10a
11)
Fig. 10b
FRONT WHEEL LOCK
12)
WARNING:
Always set
brakes when the stroller is not
being pushed so that the stroller
will not roll away. NEVER leave
stroller unattended on a hill or
incline as the stroller may slide
down the hill.
• To engage brakes, apply downward
pressure to the brake levers located on
the rear axle. The stroller may require
forward or rearward movement in order
to engage the brake (Fig. 11). Check that
the stroller will not move once the brakes
are properly applied. To release, gently
lift up on the brake levers.
WARNING:
Always
lock the front swivel wheel
in STRAIGHT position before
placing or removing your
children from the stroller and
when walking fast or jogging.

FALL HAZARD:

Prevent tipping over, before
running, jogging or walking
fast, LOCK the front wheel
from swiveling.
• The front wheel is equipped with a swivel
locking device and can lock the wheel in
the front or back position (Fig. 12a).
• Push the button on the wheel upward to
engage the locks and push downward to
disengage the locking device (Fig. 12b).
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

SAFETY

Fig. 11
Fig. 12a
Lock
Unlock
Fig. 12b
8