Nostalgia Products MDF200 Instrucciones Y Recetas página 12

11. Reassemble your AUTOMATIC MINI DONUT FACTORY.
By following these simple instructions, your AUTOMATIC MINI DONUT FACTORY
will be a fun and special treat for your family, friends and kids of all ages!
To prolong the life of your AUTOMATIC MINI DONUT FACTORY, be sure to
follow the cleaning instructions above after each and every use.
BREAKDOWN OF DOUGH DISPENSER FOR CLEANING:
1. Put your finger on the plunger as you turn the donut hopper over. You should
notice the Dough Release is extended. Unscrew this part. See illustration below.
2. Using your thumb and first finger, firmly pull up on
one end of the 'wings' , releasing it from the outer edge.
Now, release the second 'wing' the same way.
3. Now you can remove the plunger and stem assembly.
4. Turn the Dough Dispenser over and press in to release inside piece from inside mixer.
5. You should now have all four parts to the Dough Dispenser released for cleaning. Wash
in warm, soapy water. You may need to push the plunger down exposing the lower
threaded stem and confirm that the stem portion above the threads is clean and smooth.
6. Reassemble after cleaning and drying.
NOTE: You may find it
necessary to use a small, fine
brush to clean the hardened
and caked donut batter
from cracks, crevices and the
spring on the trigger stem.
Dough Release
Wing
Plunger
Outer Edge
10