Koalaty Products KB200-SS Instrucciones De Uso página 5

KB200-SS Installation Instructions
Step 3. Mount Bed and Chassis
Screw two of the mounting screws into the pilot
holes leaving ¼" (6.35 mm) exposed to allow
keyhole slots to be easily mounted over the screw
heads. Place chassis over screws as shown
in illustration. After securing the unit using the
keyhole slots, verify that the unit is level. Tighten
top two screws so that they are flush with the
wall. Use the four lower holes as a guide to mark
and drill pilot holes. Use remaining four screws
and four washers to complete installation of bed
and mounting bracket. Insert washers over lower
four screws. All SIX screws and four washers
must be properly mounted to the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from damage.
Remove key, unlock, and open liner dispenser
lid. This will expose liner dispenser mounting
holes. Line up dispenser mounting holes
onto chassis and secure with the four screws
provided. Close and lock the liner dispenser door.
Step 5. Complete Installation
Clean work area and inspect unit to ensure it
opens and closes smoothly. Give Operator Kit
and key to the facility operator. Replacement
parts and additional liners can be purchased
from your local distributor or by calling Koala at
888.733.3456 or 303.539.8300.
4