Accessory Caddy/Caster Assembly; Caster/Caster Foot Assembly - RIDGID WD12800 Manual Del Usuario

Accessory Caddy/Caster Assembly

NOTE: The accessory caddy is not
included with all models. If your Vac does
not include this caddy, continue to the
Caster/Caster Foot Assembly section.
1. Remove the power head and lid
assembly from the dust drum and set
aside.
2. Turn the dust drum upside down on the
floor.
3. Insert the accessory caddy into the
bottom of drum, as shown, on the
opposite side of the drain cap.
4. Push on the accessory caddy until it is
flush with bottom of dust drum.
5. Insert the caster stem into the socket of
the accessory caddy as shown
(2 places).
6. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.

Caster/Caster Foot Assembly

With the power head and lid assembly
removed from the drum, and the drum
upside down on the floor:
1. Insert the 2 caster feet into the bottom
of drum, as shown on the 2 locations
near the drain cap.
2. Push on the caster foot until the foot is
flush with bottom of the dust drum.
3. Insert the caster stem into the socket
of the caster foot, as shown
(2 places).
4. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
Dust
Drum
NOTE: For those Vacs that do not include
the caddy from the previous section, your
Vac will include four caster feet and four
casters. Repeat the previous instructions
on the back of the drum with the two
remaining caster feet and casters.
5. Turn the drum upright.
Caster
Foot
Dust
6
Drum
Caster
Caster Stem
Caster Ball
Accessory
Caddy
Drain
Cap
Caster
Caster Stem
Caster Ball