Buggypod lite Manual De Montaje página 5

5. ATTACHING BUGGYPOD®
TO PUSHCHAIR
Hold the Buggypod® vertically against Slide both mounting bosses, one after
the mounting brackets on the host the other, over the 4 green buttons on
pushchair. the mounting brackets, top and
bottom.
NOTE ! the mounting bosses (g) are
Ensure all 4 buttons are fully in place.
supplied un-tightened so can slide
Each button should produce an audible
along the connector bar (c).
"click" when popping through the
mounting boss holes.
6. BUGGYPOD® ALIGNMENT
If the angle of your pushchair chassis Check that Buggypod® wheel is in line
prevents this (e.g. with some 3 wheel as far as possible with the pushchair
pushchairs or those which narrow rear wheels.
at the front or rear), then you should
use the connector bar adaptor (d)
available separately from stockists
(see www.buggypod.com for a
compatibility list of pushchairs
known to require the connector
bar adaptor and Appendix A for
assembly instructions).
Tighten the grub screws on the Make sure the connector bar and
mounting bosses with the supplied Buggypod are running parallel with
small allen key the centreline of the pushchair.
If it is not, then adjust position of
mounting bosses (g) and hinge (ip)
by first loosening the grub screws,
then pushing the mounting bosses
and/or hinge as appropriate along the
connector bar until the wheel is
in line.
4
7. SETTING HEIGHT
Make sure that, when viewed from If it is not, adjust the leg height by
pulling back the black leg lock 5mm,
the rear, the Buggypod®lite seat
is level to the floor. then turn down to open lock; then
shorten or lengthen the telescopi
leg as necessary. Release the leg
lock to let it snap back into place.
8. OPENING FOOTREST
Open Footrest
If it is not, adjust the leg height by
pulling back the black leg lock 5mm,
then turn down to open lock; then
shorten or lengthen the telescopic
leg as necessary. Release the leg lock
to let it snap back into place.
5