Descargar Imprimir esta página

hager G441-30X Manual De Instalación página 43

Transmisor telefónico gsm

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
 Real tests
I Step 1: Close the cover.
I Step 2: Change to normal user mode.
The change to Normal user mode is possible:
• if the 2 telephone dialler anti-tamper mechanisms are activated (the dialler must be mounted on its fixing plate
and its cover must be closed),
• if the necessary programming has been performed, i.e.:
- date and time
- SIM pin code
- SIM PUK code
- user code
- radio type selection (applies to G470-30X)
- at least one programmed hardwired input (applies to G442-30X and G450-30X)
- at least one phone number allocated to the alarm call cycle
- APN (operator access name) must be informed if protocol ViewCom IP have been choosed,
• if the GSM dialler does not display "fault, battery",
• if there is not enough memory on the SIM card, the telephone dialler cannot switch to normal operating mode
and displays "Error".
Drop-down menu shown Steps to be followed
Set up
User mode
User mode
User mode
User mode
Please wait
User mode
DD MM YY hh mm
2 minutes after the changeover to User mode, the GSM dialler transmits the configuration change message.
I Step 3: Perfoming differents real tests
PERFORMING A REAL TEST WITH THE HAGER ALARM
• Trigger the alarm control panel and check that the G470-30X dialler calls the correspondents in its call cycle.
• This test is used to check the radio link between the control panel and the dialler, as well as the correspondent call procedure.
PERFORMING A REAL TEST ON THE DIALLER ANTI-TAMPER SYSTEM
• Trigger the dialler by opening its cover.
• Check that the call procedure to correspondents works.
PERFORMING A REAL TEST ON ONE OF THE DIALLER'S INPUTS
• Trigger one of the dialler's inputs and check that the dialler calls the correspondents in its call cycle.
• This test is used to check that the input has the right parameter setting (filtering time, etc.) and that the correspondent call procedure is
carried out properly.
• Press (OK) to validate
The change to Normal user mode may take a while,
please wait until until this message is displayed.
43
G

Publicidad

loading

Productos relacionados para hager G441-30X

Este manual también es adecuado para:

G442-30xG450-30xG470-30x