Installation Instructions; Mechanical Mounting - Maxon MCB-10A Manual De Instrucciones

INSTALLATION INSTRUCTIONS

Mechanical Mounting

CAUTION: Be sure the unit is mounted where it
will not interfere with the driver or impair access
to any controls necessary for the safe driving of
the vehicle. The radio's power and/or antenna
connecting cables must be routed and secured so
that they do not interfere with the operation of the
brake, accelerator or other controls. Interference
from either the CB unit or its connecting cables
may contribute to the loss of control of the vehicle.
1) Use the power/antenna connector box as a
template for marking the location of screw
holes (self-tapping screws provided).
2) Drill the necessary holes and secure the
power/antenna connector box with the
self-tapping screws.
NOTE: EXTREME CARE SHOULD BE EXERCISED
WHEN DRILLING UP INTO THE DASH to avoid
damage to in-dash electronic ignition wiring, air
bag or air bag sensors, cruise control, instruments
or accessory wiring.
3) If you choose to mount the power/antenna
connector box under the vehicle seat or at an
alternate location where self-tapping screws
cannot be used, determine the most secure
method of fastening the power/antenna
connector box. Use strong mounting tape,
plastic tie wraps, etc.
4) Use the three included screws to mount the
transceiver hanger bracket onto the vehicle's
dash.
6