Operating The Sprayer - The Fountainhead Group 190197 Manual Del Usuario

OPERATING THE SPRAYER

Filling
IMPORTANT: Always make sure the
pressure is released from the tank before
filling or servicing. Pull up on the knob of
the pressure release valve until all the
pressure is released from the tank. Then,
and only then, it is safe to remove pump.
1. Turn the pump handle counterclockwise to
remove the pump. See Figure 5.
2. Fill the tank to the desired level. (Always
refer to chemical manufacturer for proper
mixture).
3. Install the pump into the tank opening and
turn clockwise until tightly sealed against
the tank. See Figure 6.
Pressurizing
1. Make sure shut-off lock is not engaged. (If
shut-off lock is engaged while pressurizing,
the unit will immediately start spraying).
2. Push down on the handle and turn counter-
clockwise to unlock the handle.
3. Pressurize the sprayer by pumping the
handle in a smooth up and down motion.
See Figure 7.
4. Push down on the handle and turn
clockwise to lock the handle into the pump.
Figure 5.
Remove the Pump
Figure 7. Pressurize the Tank
3
Figure 6.
Install the Pump