Plug In Receiver; External Aerial; Control Panel; Use Of The Programming Wheel - Key Automation 900CT-101 Manual De Instrucciones

PLUG IN RECEIVER

900CT-101 control unit is suitable for plugging in a Personal
Pass 900RXI-44 receiver having a high-sensitivity super-
heterodyne architecture.
WARNING: it is necessary to turn off the control unit
power before doing the operations mentioned here below. Pay
attention to the way you connect the removable modules.
900RXI-44 module receiver is provided with 4 channels and
each of them is suitable for a command of 900CT-101 control
unit:
CHANNEL 1 START
CHANNEL 2 PEDESTRIAN START
CHANNEL 3 STOP
CHANNEL 4 COURTESY LIGHT
WARNING: Before programming 4 channels and function
logics read carefully the instructions of 900RXI-44.

EXTERNAL AERIAL

We suggest to use the external aerial in order to guarantee the
maximal range.
Connect the antenna hot pole to terminal A2 of the control unit
and the braiding to terminal A1.

CONTROL PANEL

When power is on, the control unit checks that display correctly
operates by switching on all segments for 1.5 sec. 8.8.8.8.
Firmware version, e.g. Pr 2.0, will be viewed in the following 1.5
sec. Panel will be viewed upon completion of this test.
The control panel represents the physical status of the
terminal board contacts and of the program mode keys: if the
upper vertical segment is on, the contact is closed; if the lower
vertical segment is on, the contact is open (the picture above
shows the case of START, START P , STOP , FOTO, COSTA, FCA and
FCC inputs correctly connected with the gate closed).
Points being among display digits show the status of
programming push-buttons: as soon as a push-button is
pressed, its relevant point turns on.
The arrows on the display right side show the gate status:
• The highest arrow turns on when the gate is into its opening
phase. If it blinks, it means that the opening has been
caused by a safety device (border or obstacle detector).
• The central arrow shows that the gate is on pause. If it
blinks, it means that the time countdown for the automatic
closing has been activated.
• The lowest arrow blinks when the gate is into its closing
phase. If it blinks, it means that the closing has been
caused by a safety device (border or obstacle detector).

USE OF THE PROGRAMMING WHEEL

The control unit can be programmed through the configuration
menu, accessible by the special programming wheel.
WARNING: Outside the configuration menu, pushing the
wheel upwards a START control is given, pushing it downwards
(DOWN) a PEDESTRIAN START control is given.
To start the programming mode while the display is showing
the control panel, keep the wheel pressed until the display
shows dEF.
The configuration menu consists in a list of configurable items;
the display shows the selected item; pushing the wheel
downwards the following item is selected, pushing the wheel
upwards the previous item is selected. Pressing the wheel the
current value of the selected item is displayed and it is
possible to change it, if necessary.
The last item of the menu (FinE) allows to store the changes
made and to revert to the normal working of the control unit. In
order not to loose the own configuration it is compulsory exiting
through this menu item.
WARNING: If no operations are required for more then a
minute, the control unit exits from the programming mode
without saving the given information and changes will be lost.
Keeping the wheel pushed downwards the configuration menu
items are quickly scrolled down until displayed the item FinE.
Likewise, keeping the wheel pushed upwards the items are
quickly scrolled down backwards until reached the item dEF.
Like this, the beginning or the end of the list can be reached
quickly.
There are the following three kinds of menu items:
• Function menu
• Time menu
• Value menu
23