Torin BIG RED TRA8205B Manual Del Propietário página 9

OPERATING INSTRUCTIONS
TO RAISE A LOAD
1. Place the jack on a hard and level surface beneath the load that is to be lifted.
2. Following all safety precautions, place the foot of the jack beneath the load. Lift the reversing latch (20) to
the "UP" position and ensure it is locked in place. With the indentation in the latch firmly engaged in the
notch on the reversing switch (18) (see figure 1), jack up the nose until it comes into contact with the load
at the desired point of lift. Make sure a pause on this stage and check to ensure there are no obstacles for
a clean lift.
3. Pull down firmly and evenly on the handle and observe the load when rising. As the handle is pulled down,
you will hear the Climbing Pin (15) click into place as it locates in a hole in the steel bar (3). At this point,
relax the handle allowing the pin (15) to take the load. Raise the handle to the top of its stroke to take a
fresh purchase and pump the handle once again.
RAISING A VEHICLE
THIS IS A LIFTING DEVICE ONLY!
• This jack is designed only for lifting part of the total vehicle.
• Do not move or dolly the vehicle while on the jack.
• The vehicle must be supported after lifting immediately by appropriately rated jack stands.
• NEVER go under a vehicle that is not supported with appropriately rated jacks stands.
• Use wheel chocks or other blocking device on opposing wheels before using jack stands.
Never work under raised equipment unless additional supports are used under the lifted equipment.
1. Securely chock and block (stabilize) the load you are going to lift. This will prevent it from rolling or shifting
as you lift it.
2. Keep the handle against the steel standard (column) when not lifting or lowering.
UP
DANGER: Always place the handle against the steel standard (bar) before moving
the reversing latch. This will prevent the handle from moving up and down rapidly,
which could cause serious injury or death if it comes into contact with any part of your
body. Always keep your head out of the travel path of the handle.
REVERSING LATCH
DOWN
9