Installing The Wall Control - Hinkley TREY 52 Manual De Instrucciones

INSTALLING THE WALL CONTROL

REMEMBER to turn off the power before you begin.
NOTE - Control must be installed within 30 feet of fan.
Remove the existing wall plate and the old switch from the
1
wall outlet box. (Fig. 1)
Connect the wiring from the wall switch receptacle to wall
2
transmitter unit
Connect one BLACK wire from the wall to one BLACK wire
(labeled "TO FAN") from the wall transmitter.
Connect the other BLACK wire (labeled "TO POWER
SUPPLY") from the transmitter to the remaining BLACK wire
from the wall (A/C supply source).
Connect the green ground wire form the switch to the ground
3
wire on the wall outlet box.
Install the wall transmitter on the existing wall outlet box using
4
the screws provided. Attached the wall plate with the
mounting screws to finish the installation. (Fig. 2)
Outlet box
Switch
Fig. 1
Transmitter
Fig. 2
©2019 Hinkley Lighting, Inc. | hinkley.com |
Wall plate
Decorative Wall Plate
11