Wiring Connections - Sub-Zero ICB424 Instrucciones De Instalación

Models ICB427 and ICB427R Installation

Wiring Connections

Before the kickplate/grille is installed, all necessary wiring
connections in the compressor compartment should be
completed.
If the dual installation heater kit (7007529) is used with
model ICB427 or ICB427R, the power supply leads should
be connected according to instructions included with the
kit.
If a home alarm system is to be installed on the wine
storage unit, the connections should be made using the
logic supplied with the alarm specifications. Refer to the
illustration below for the appliance lead locations, and
refer to the following for color codes:
• Normally open contacts: white with red stripe wire.
• Normally closed contacts: white with blue stripe wire.
• Common: gray with white stripe wire.
Use the 6 mm spade terminals or wire nuts provided to
make the proper wiring connections.
HOME ALARM
CONNECTIONS
Home alarm connections.
IMPORTANT NOTE: If you are not responsible for alarm
system connection, this information should be supplied to
the home security system contractor.
The alarm circuit in the unit is intended as a low-
voltage, low-current device only. It should not be
used to switch line power.
Any unused terminals should be completely insu-
lated and all wires should be secured away from
conductive or moving components.
Kickplate/Grille
Once the unit is leveled and wiring connections made, the
kickplate/grille can be installed.
IMPORTANT NOTE: The kickplate/grille must be removed
for servicing. The floor cannot interfere with removal. The
louvered section of the kickplate/grille must not be
covered so as to prevent air circulation.
For models ICB427 and ICB427R, there is some adjust-
ment to the mounting assembly so that the kickplate/grille
can fit flush with the surrounding area. Refer to the illustra-
tion below.
IMPORTANT NOTE: The unit must be allowed to have ven-
tilation through the fins of the kickplate/grille. You may
cover the solid area, but do not block the fins. For model
ICB427R, the lower drawer panel may hang in front of the
fins, but your baseboard molding must not cover them.
Turn power back on to the electrical outlet.
Kickplate/grille installation.
subzero.com
Door Panels
Models ICB427 and ICB427R are available as a glass door
(G) or solid door (S) model. Each of these wine storage
units are set up at the job site as either the stainless steel
or integrated design.
Stainless steel panels—available as sales accessories—
may be configured several ways and are shipped sepa-
rately. Stainless steel panels are shipped with matching
handles in place.
The integrated design uses custom wood or other decora-
tive panels and handles provided by the customer.
Model ICB427R requires solid panels on the drawers that
may match the door panel, or be complementary. The
model ICB427R stainless steel drawer panel set and stain-
less steel door panel are ordered and shipped as two
items.
The solid door model ICB427/S or ICB427R/S—with no
glass window—requires a different door panel than the
glass door design.
Before beginning installation, check for the correct com-
ponents for the fit and finish desired. The door and
drawers (model ICB427R) require a decorative panel that
is a minimum 16 mm thick.
If you have questions, contact your Sub-Zero dealer or
cabinet supplier. Additional panel information can be
found in the Sub-Zero design guide, or visit our website at
subzero.com.
A solid panel must not be installed on a glass door
unit, as this may cause moisture to form behind the
panel.
13