Canopy Assembly; Blade Assembly - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely. Slide canopy
cover up to canopy, aligning rounded part of
slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 12 blade attachment screws and
washers in one of the hardware packs. Slide
blade through one of the narrow, rectangular
openings on motor housing, aligning holes in
blade with holes in blade arm (located inside
the rectangular opening in the motor
housing)--refer to drawing at right. Insert 3
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade arm screws twice a year.
receiver
canopy
screw
blade attachment
screws and washers
motor housing
(topside)
page 7
antenna
hanging
bracket
screw
canopy cover
blade
blade
arm