Light Kit Assembly - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

9. Light Kit Assembly.

motor housing
blade
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes in
center of fitter plate with loosened screws in
motor plate, allowing molex connections from
motor housing to come through hole in middle
of fitter plate. Twist fitter plate to lock. Re-insert
motor plate
screw that was previously removed and
securely tighten all 3 screws with Phillips
screwdriver.
fitter plate
molex connections
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
motor housing
Connect WHITE wire from motor housing to
WHITE wire from light kit fitter. Connect BLACK
wire from motor housing to BLACK wire from
light kit fitter. Be sure molex connections snap
blade
together securely.
Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
fitter plate
fitter to lock. Re-insert screw that was
nodule
previously removed and tighten all 3 screws
securely.
molex
connections
Install two 50 watt max. halogen bulbs, type JD
E11 (included).
light kit fitter
Important: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
bulb
touching them.
Tip: Do not touch glass portion of bulb with
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
glass shade
slot
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
Align grooves on glass shade with nodules on
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
page 8