Automated Learning Process./ Activating Code; Wall Control Operation - Craftmade ELLINGTON UBR48BNK4 Manual De Instrucciones

10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off
to any other programmable receiver or fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to other
remote units such as garage door openers, car alarms or
security systems. If you find that your fan and light go on and
off without using your remote control, simply change the
combination code in your remote control transmitter (and wall
control). To set the code, perform these steps:
Remove battery cover from back side of transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same number
sequence used when wiring the wall control in Section 6.
Note: Since this fan comes with halogen bulbs, the dimmer
switch (labeled D and X) has been pre-set to the "ON"
position (D). If you do not wish to have dimming capability,
please move the switch to the "OFF" position (X).
Install 9-volt battery (included) in transmitter and then
re-attach the battery cover..
[IMPORTANT: To prevent damage to transmitter, remove the
battery if not used for long periods.]
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning on the
wall control, press and hold the "OFF" button on the front of
the transmitter for 5 seconds or until light on fan blinks twice.
Test the fan and light functions to confirm the learning
process is complete--see Section 13.

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
LIGHT button - turns light ON/OFF when pressed
once; dims light when pressed and held down
(back)
page 9
TRANSMITTER
(front)
code
switches
pen
dimmer
switch
battery
battery
cover